BLOG

To position a lid stay correctly, do not start by drilling the two bracket patterns shown on a catalog drawing. Start with the real hinge axis, the finished cover center of gravity,…

A machine door can open smoothly and still be incorrectly designed at the end of its travel. Without a defined structural stop, the door may rotate until a hinge leaf contacts the…

A machine door hinge assembly validation should prove more than whether a loose hinge looks correct or rotates on an inspection bench. The completed door may still sag after its temporary support…

A bolt-on hinge can have adequate catalog load capacity and still produce a machine door that sags, shifts, or loosens in service. The hinge may be acceptable while the mounting holes elongate,…

A machine access door can use a hinge with adequate catalog capacity and still fail during fabrication. The door may fit correctly after tack welding, then bind after the final welds. The…

An EV charging cabinet may contain a public-facing control door, a technician-only power compartment, a cooling-service panel, and a cable-termination access door. These doors do not necessarily need the same hinge. Their…

A battery energy storage system may include several access doors within the same cabinet or enclosure. A battery compartment door, power-electronics door, control-service panel, and cooling-access door can differ in weight, opening…

When you open an equipment cover and let go, where should it stop? That is the real difference between a free-stop and a fixed-angle lid stay. A free-stop lid stay holds the…

When a lid or top cover needs to be held open on an enclosure, two mechanisms handle the job in different ways. A telescopic lid stay extends and retracts along a sliding…

A lid stay holds a lid or cover open at a safe angle so it does not slam shut on a hand. Two common types do this in different ways. A friction…

When an electrical cabinet door needs a single latching point, a quarter-turn cam latch and a swing handle can both do the job — but they solve different problems. A quarter-turn cam…

A control cabinet holds the switches, PLCs, and wiring that keep a machine or process running, and the cam latch on its door decides one thing before anything else: can just anyone…